Intel Desktop Board D915GVWB Recovery BIOS 1319 Descritpion: Intel Desktop Board D915GVWB Recovery BIOS 1319
WARNING!!!
For all BIOS versions prior to WB91x10J.86A.1037, you must first update to BIOS version WB91x10J.86A.1037. Once you have updated the system to WB91x10J.86A.1037, then you may complete any other BIOS updates.
In the unlikely event that a flash update is interrupted it is possible the BIOS may be left in an unusable state. Recovering from this condition requires the following steps (be sure a floppy drive is connected as drive A):
WARNING: This process is intended to be performed by a trained technician.
Note: The floppy disk does NOT need to be bootable. However, the floppy disk must be formatted.
1. Copy the recovery file (*.bio) to floppy diskette.
2. Place the diskette in the floppy drive (drive A) of the target system.
3. Remove the BIOS Configuration Jumper. See the Technical Product Specification for details including the location of this jumper.
4. Power the system on.
5. Wait 2-5 minutes for the update to complete. No video is available during the BIOS update procedure. When the floppy drive LED is lit, the system is copying the recovery code into the FLASH device.
6. System will turn off when the recovery process is completed.
7. Remove floppy in drive A:
8. Restart system
NOTE: If the error message "CMOS/GPNV Checksum Bad¡Press F1 to Run SETUP" appears during boot, then press [F1] to go into the "BIOS Setup |
Downloads Top